BERNINA 900 Nova Foot Controller Connector Repair Kit
Repair Kit - Foot Controller Connector for BERNINA 900 Nova
Connector Covers
4x screw & nuts
3x cable clamps
Instant downloads
Worldwide Shipping & VAT
Terms and conditions of use
Assembly:
First cut off the connector you are going to use at the blue line. Gradually cut in to the green line which is 5mm away from the red line. Check the fit as you approach the green line so you don't cut off too much.
Note! Check the colors of the wires and which pin they lead to.
Loosen the set screws completely before pressing the wire clamps into place. Then tighten the screws well. Make sure that the direction of the guide (marked with a green ring) is as in the picture and that the screws point upwards.
Strip the insulation and fasten the wires in the corresponding color order that you noted when the plug was cut. The most common is the order as in the picture, but it may be that yours is a little different from everyone else's... So just to be sure ;)
Then attach the upper part with the screws and tighten so that there is no obvious variation in the distance between the two parts.
Now the connector on the foot controller is in order, and the Nova is just waiting to give you many more quality hours!
You find electronic schematics for BERNINA 900 Nova here: syrep.no/repair