stl-file for Motor Clamps - BERNINA 910 - 931

Files:
Clamp_No1_910-931.stl
Clamp_No2_910-931.stl
Clamp_No3_910-931.stl
3D-Print Info.pdf

No additional parts needed

Slicing
No pre-sliced print files attached since the result depends on the printer and type of filament.

Recommended Print Settings
Supports: Everywhere
Infill: 100%
Filament: PETG
Nozzle diameter: 0.4 mm
Layer height: 0.2 mm

Amount of filament used, based on this settings:
Clamp No.1: 4 Gram PETG
Clamp No.2: 5 Gram PETG
Clamp No.3: 3.5 Gram PETG

Note!
The size of the printout from the individual 3D Printers may vary slightly. Therefore, the printout may need some finishing work.

Standard Digital File Licence
Digital files (*.fbx *.obj *.stl *.gcode and other files) sold on 3dsewingparts.com have a strict non-commercial, personal use only license.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital file or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - remixes of this object).

You can not host this files on other digital platforms, web stores, cloud repositories WITHOUT OUR PERMITION.

Franchising:
In case you have bought 3D printing files under Standard Digital File Licence and you want to 3D print physical products commercially, you can contact us at: post@syakademiet.no

Questions about the Terms & Conditions should be sent to us at: post@syakademiet.no